Snow helmets have come a long way since the early 2000s, when few skiers wore one. Better styling and safety features helped change that, and POC has been at the forefront of both. The Obex BC MIPS shows where that’s led, with 11 vents, understated styling, and a strong safety package.
POC Obex BC MIPS Key Specs
- Shell: Dual-material polycarbonate with an ABS top section and aramid panels
- Liner: EPS with MIPS Evolve
- Certification: ASTM F2040 and EN 1077B
- Ventilation: 11 vents total, 3 of them adjustable on top
- Fit: 360° rear dial, removable ear pads
- Extras: RECCO reflector, Twiceme NFC Medical ID
- Size Tested: XL-XXL (59 – 62cm)
- Weight: 495 grams. 577 grams with ear pads. measured on my scale.
- Testers head size: 62cm

Fit and Comfort
The POC Obex BC MIPS (hereafter to be referred to as the Obex BC) is a super comfortable helmet. It’s padding is thick enough at the fore and top of head and then thins to nearly nothing where the pads connect to each other. It’s padded where needed and thins to save weight. The padding is easily removable for washing thanks to the small velcro tabs holding it in place.
At the back of the helmet is the 360° Fit System. This consists of a coil dial (think Boa) attached to a harness that wraps all the way around the helmet giving a reliable squeeze when tightened. Adjusting the height of the harness, and thus it’s position on the occipital bone, is easy thanks to a three step notch system embedded into the helmet. The 360° Fit System is also padded at the back of the head, something I have not seen on other helmets I have tested, and is a nice addition for when you aren’t wearing a cap underneath.
A note about the shape of the helmet. It does fit somewhat “rounder” than other helmets I have worn like the Smith Vantage or Mammut Haute Route. This is not a negative, merely a comment on the shape. My biggest gripe is that I cannot wear my beloved softshell Montbell hats under this helmet as I am at the maximum head size range this helmet will take.
Warmth and Ventilation
The Obex BC has a total of 11 vents spread throughout. Two vents at the front of the helmet channel air downward and to the top of the goggles to keep them from fogging up. Conversely, at slower speeds they allow air to dissipate without getting blocked by the underside of the helmet. I never noticed goggles fogging up while wearing the Obex BC, whether that was with the a pair of Anon M4 or POC Fovea.

The three vents at the top of the helmet can be opened in two stages. In practice with winter gloves, I found I would just slide the vents from fully closed to fully open or vice versa. The vents are relatively small but do an adequate job of allowing some light airflow. They are mostly for allowing heat out. Finally there are four vents at the back of the helmet to help dump heat from the back of the head.
The Obex BC earpads are shaped like small corrals for your ears. There is no pressure on your ear when worn. This means the ear pads are a bit thin and are not quite as warm as others. However it does mean hearing is better with the Obex BC ear pads as they are thinner.
he earpads are easily removed thanks to a simple notch system.You’ll want a balaclava on or thin beanie for days much colder than -10°C. That’s not a problem for me as I usually wear one anyway to protect the rest of my face. You obviously want something over your ears should you ditch the ear pads altogether. If you have a large head like myself, you’ll want a thin merino beanie or headband. The Arcteryx Proton hat also works, if you can find it.
Classic Protection
The POC Obex BC MIPS has a slew of tricks up its sleeve to keep the wearer safe in the event of a sudden stop on the cranium.
First up is MIPS Evolve. This is an updated version of MIPS that retains the low-friction sliding layer of the original which is now called MIPS Essential. According to MIPS, Evolve is refined for lighter construction, ventilation and a better fit. Honestly, I cannot tell the difference while wearing the helmet and I suppose that is the point.

The Obex BC also has a RECCO reflector built in. In the event you are lost in the backcountry or in an avalanche without a transceiver, rescuers can deploy a RECCO detector. This detector emits radio waves and uses their reflected signal to help locate the wearer. The more reflectors you have the more likely you are to be pinpointed. All metal will reflect the radio waves but the RECCO reflectors themselves are markedly better at it. I have no idea where the RECCO reflector is hidden in the helmet.
The outer shell of the Obex BC is made of polycarbonate with an ABS top section. The polycarbonate and ABS give strength at a low weight and handles the small bumps and bashes that may otherwise damage the EPS unnecessarily. Think of your helmet rolling around in the back of your car or when someone overzealously pulls the safety bar on the chair down too fast. The ABS handles smaller bumps and scrapes without showing much wear, so the helmet keeps looking fresh.The Obex BC’s liner is made of EPS, expanded polystyrene. This is a foam that is essentially made of air pockets that collapse on impact to absorb energy.
Aramid panels sit between the shell and liner. Aramid is a strong synthetic fiber in the same family as Kevlar, and it adds structural stability and further penetration protection.
After travelling to Japan with mine in check in with my board, then using it for three weeks ducking and dodging branches at full Japow speed there are less than a handful of small inconsequential dents. Let me be clear, I have been aggressive with this helmet and it has stood up well.
Modern Tech
A new addition to helmets for me is Twiceme. This is an app and an NFC chip embedded into the Obex BC that retains vital info should the helmet wearer be in an accident and be unable to share this info themselves.
Set up begins on the Twiceme app where you enter what Twiceme calls Medical ID. These are things such as blood type, allergies, other medical conditions, and emergency contacts into the app. You do not scan your actual Medical ID. I was a bit confused at first. When you open the App it will also give your location on a map and your co-ordinates should you not be able to access them via your mapping app.
Then, to register your gear you tap your smartphone against the Twiceme symbol on your Obex BC to write and store that information directly onto the embedded NFC chip. It’s really quite simple however it takes up to ten seconds for my iPhone 15 Pro to communicate with the NFC chip sometimes.
It also stores when you first started using the helmet. This is important as the materials used in helmets deteriorate over time. Industry standards suggest a helmet should be taken out of service after five years of use.
When your helmet is scanned there is also an option to call emergency services. As well as notifying local emergency services the app will also send emails or SMS to your emergency contacts. They will obviously not know what is wrong but that its time to mobilize as well and be ready to be contacted by emergency services.
Safety Certifications
The Obex BC has two certifications. The first is the ASTM F2040, which is the American standard for skiing and snowboarding. Its other certification is the EN 1077B which is the European standard for impact protection and retention for skiing and snowboarding. It’s nice to know that this helmet has passed the industry standards for safety. It is not a multi-sport helmet however. It’s not meant for cycling nor climbing. If you are looking for a helmet that does all the tricks, POC offers the Calyx.
Weight
At 495 grams without earpads the POC Obex BC MIPS is a little hefty, though on my scale, not as hefty as PCO reports.. It’s not the first helmet I reach for when I know I am going to have a big day on the skin track. However, it is the helmet I reach for when going mechanized riding, be that with a helicopter or a lift. I want something that can take being tossed around inside a gondola or on the dash of a helicopter. Perhaps a guest will kick it when I take it off for lunch and for that I want something designed for a little more rough and tumble. That’s the POC Obex BC MIPS.
Durability
I wore the helmet for about thirty days last winter so it is more than ready for duty this winter. I typically like to wear gear more before reviewing it but a chance meeting with a tree meant my review season ended a little earlier than planned. My main testing period of the Obex BC use was taking a nearly month-long trip to Japan. It got tossed into my ski bag, into the back of a van, and took head down charges into the Japow laden bush. It shows a few dents but I have thrown everything but the kitchen sink at it. It has stood up incredibly well. It is warm enough to take on most any winter storm while the incredibly easy to remove earpads allow for customization at a snap.
Who the POC Obex BC MIPS is for

The POC Obex BC MIPS is one of the most comfortable backcountry helmets around, especially if you have a rounder head shape. Its construction should inspire confidence for those who buy a helmet for multiple years. Polycarbonate, ABS and Aramid panels will sustain a lot of minor abuse from day to day rough housing. EPS foam and MIPS are tried and true. Twiceme is a great addition and on the surface I think it is a great concept. I hope I never find out how well it works.
The helmet is a little on the heavy side and if I was solely a ski tourer I might find myself reaching for a lighter helmet. However, if I can get pow with a lift, cat, shuttle, or heli I will. I want a helmet that is going to stand up to the little bumps that are inherent in this kind of riding along with a bit of splitboarding and this is right where the POC Obex BC Mips fits in.
If you are looking to pick one up, smash the link: POC Obex BC MIPS
Disclaimer
Black Sheep Adventure Sports was provided with a free sample of the POC Obex BC MIPS. This in no way affected our opinion and review.













